1/* SPDX-License-Identifier: GPL-2.0 */
2/*
3 * Copyright (c) 2000-2008 LSI Corporation. All rights reserved.
4 *
5 * NAME: fc_log.h
6 * SUMMARY: MPI IocLogInfo definitions for the SYMFC9xx chips
7 * DESCRIPTION: Contains the enumerated list of values that may be returned
8 * in the IOCLogInfo field of a MPI Default Reply Message.
9 *
10 * CREATION DATE: 6/02/2000
11 * ID: $Id: fc_log.h,v 4.6 2001/07/26 14:41:33 sschremm Exp $
12 */
13
14
15/*
16 * MpiIocLogInfo_t enum
17 *
18 * These 32 bit values are used in the IOCLogInfo field of the MPI reply
19 * messages.
20 * The value is 0xabcccccc where
21 * a = The type of log info as per the MPI spec. Since these codes are
22 * all for Fibre Channel this value will always be 2.
23 * b = Specifies a subclass of the firmware where
24 * 0 = FCP Initiator
25 * 1 = FCP Target
26 * 2 = LAN
27 * 3 = MPI Message Layer
28 * 4 = FC Link
29 * 5 = Context Manager
30 * 6 = Invalid Field Offset
31 * 7 = State Change Info
32 * all others are reserved for future use
33 * c = A specific value within the subclass.
34 *
35 * NOTE: Any new values should be added to the end of each subclass so that the
36 * codes remain consistent across firmware releases.
37 */
38typedef enum _MpiIocLogInfoFc
39{
40 MPI_IOCLOGINFO_FC_INIT_BASE = 0x20000000,
41 MPI_IOCLOGINFO_FC_INIT_ERROR_OUT_OF_ORDER_FRAME = 0x20000001, /* received an out of order frame - unsupported */
42 MPI_IOCLOGINFO_FC_INIT_ERROR_BAD_START_OF_FRAME = 0x20000002, /* Bad Rx Frame, bad start of frame primitive */
43 MPI_IOCLOGINFO_FC_INIT_ERROR_BAD_END_OF_FRAME = 0x20000003, /* Bad Rx Frame, bad end of frame primitive */
44 MPI_IOCLOGINFO_FC_INIT_ERROR_OVER_RUN = 0x20000004, /* Bad Rx Frame, overrun */
45 MPI_IOCLOGINFO_FC_INIT_ERROR_RX_OTHER = 0x20000005, /* Other errors caught by IOC which require retries */
46 MPI_IOCLOGINFO_FC_INIT_ERROR_SUBPROC_DEAD = 0x20000006, /* Main processor could not initialize sub-processor */
47 MPI_IOCLOGINFO_FC_INIT_ERROR_RX_OVERRUN = 0x20000007, /* Scatter Gather overrun */
48 MPI_IOCLOGINFO_FC_INIT_ERROR_RX_BAD_STATUS = 0x20000008, /* Receiver detected context mismatch via invalid header */
49 MPI_IOCLOGINFO_FC_INIT_ERROR_RX_UNEXPECTED_FRAME= 0x20000009, /* CtxMgr detected unsupported frame type */
50 MPI_IOCLOGINFO_FC_INIT_ERROR_LINK_FAILURE = 0x2000000A, /* Link failure occurred */
51 MPI_IOCLOGINFO_FC_INIT_ERROR_TX_TIMEOUT = 0x2000000B, /* Transmitter timeout error */
52
53 MPI_IOCLOGINFO_FC_TARGET_BASE = 0x21000000,
54 MPI_IOCLOGINFO_FC_TARGET_NO_PDISC = 0x21000001, /* not sent because we are waiting for a PDISC from the initiator */
55 MPI_IOCLOGINFO_FC_TARGET_NO_LOGIN = 0x21000002, /* not sent because we are not logged in to the remote node */
56 MPI_IOCLOGINFO_FC_TARGET_DOAR_KILLED_BY_LIP = 0x21000003, /* Data Out, Auto Response, not sent due to a LIP */
57 MPI_IOCLOGINFO_FC_TARGET_DIAR_KILLED_BY_LIP = 0x21000004, /* Data In, Auto Response, not sent due to a LIP */
58 MPI_IOCLOGINFO_FC_TARGET_DIAR_MISSING_DATA = 0x21000005, /* Data In, Auto Response, missing data frames */
59 MPI_IOCLOGINFO_FC_TARGET_DONR_KILLED_BY_LIP = 0x21000006, /* Data Out, No Response, not sent due to a LIP */
60 MPI_IOCLOGINFO_FC_TARGET_WRSP_KILLED_BY_LIP = 0x21000007, /* Auto-response after a write not sent due to a LIP */
61 MPI_IOCLOGINFO_FC_TARGET_DINR_KILLED_BY_LIP = 0x21000008, /* Data In, No Response, not completed due to a LIP */
62 MPI_IOCLOGINFO_FC_TARGET_DINR_MISSING_DATA = 0x21000009, /* Data In, No Response, missing data frames */
63 MPI_IOCLOGINFO_FC_TARGET_MRSP_KILLED_BY_LIP = 0x2100000a, /* Manual Response not sent due to a LIP */
64 MPI_IOCLOGINFO_FC_TARGET_NO_CLASS_3 = 0x2100000b, /* not sent because remote node does not support Class 3 */
65 MPI_IOCLOGINFO_FC_TARGET_LOGIN_NOT_VALID = 0x2100000c, /* not sent because login to remote node not validated */
66 MPI_IOCLOGINFO_FC_TARGET_FROM_OUTBOUND = 0x2100000e, /* cleared from the outbound queue after a logout */
67 MPI_IOCLOGINFO_FC_TARGET_WAITING_FOR_DATA_IN = 0x2100000f, /* cleared waiting for data after a logout */
68
69 MPI_IOCLOGINFO_FC_LAN_BASE = 0x22000000,
70 MPI_IOCLOGINFO_FC_LAN_TRANS_SGL_MISSING = 0x22000001, /* Transaction Context Sgl Missing */
71 MPI_IOCLOGINFO_FC_LAN_TRANS_WRONG_PLACE = 0x22000002, /* Transaction Context found before an EOB */
72 MPI_IOCLOGINFO_FC_LAN_TRANS_RES_BITS_SET = 0x22000003, /* Transaction Context value has reserved bits set */
73 MPI_IOCLOGINFO_FC_LAN_WRONG_SGL_FLAG = 0x22000004, /* Invalid SGL Flags */
74
75 MPI_IOCLOGINFO_FC_MSG_BASE = 0x23000000,
76
77 MPI_IOCLOGINFO_FC_LINK_BASE = 0x24000000,
78 MPI_IOCLOGINFO_FC_LINK_LOOP_INIT_TIMEOUT = 0x24000001, /* Loop initialization timed out */
79 MPI_IOCLOGINFO_FC_LINK_ALREADY_INITIALIZED = 0x24000002, /* Another system controller already initialized the loop */
80 MPI_IOCLOGINFO_FC_LINK_LINK_NOT_ESTABLISHED = 0x24000003, /* Not synchronized to signal or still negotiating (possible cable problem) */
81 MPI_IOCLOGINFO_FC_LINK_CRC_ERROR = 0x24000004, /* CRC check detected error on received frame */
82
83 MPI_IOCLOGINFO_FC_CTX_BASE = 0x25000000,
84
85 MPI_IOCLOGINFO_FC_INVALID_FIELD_BYTE_OFFSET = 0x26000000, /* The lower 24 bits give the byte offset of the field in the request message that is invalid */
86 MPI_IOCLOGINFO_FC_INVALID_FIELD_MAX_OFFSET = 0x26ffffff,
87
88 MPI_IOCLOGINFO_FC_STATE_CHANGE = 0x27000000 /* The lower 24 bits give additional information concerning state change */
89
90} MpiIocLogInfoFc_t;
91

source code of linux/drivers/message/fusion/lsi/mpi_log_fc.h