1/* SPDX-License-Identifier: GPL-2.0 */
2/*
3 * omap_udc.h -- for omap 3.2 udc, with OTG support
4 *
5 * 2004 (C) Texas Instruments, Inc.
6 * 2004 (C) David Brownell
7 */
8
9/*
10 * USB device/endpoint management registers
11 */
12
13#define UDC_REV (UDC_BASE + 0x0) /* Revision */
14#define UDC_EP_NUM (UDC_BASE + 0x4) /* Which endpoint */
15# define UDC_SETUP_SEL (1 << 6)
16# define UDC_EP_SEL (1 << 5)
17# define UDC_EP_DIR (1 << 4)
18 /* low 4 bits for endpoint number */
19#define UDC_DATA (UDC_BASE + 0x08) /* Endpoint FIFO */
20#define UDC_CTRL (UDC_BASE + 0x0C) /* Endpoint control */
21# define UDC_CLR_HALT (1 << 7)
22# define UDC_SET_HALT (1 << 6)
23# define UDC_CLRDATA_TOGGLE (1 << 3)
24# define UDC_SET_FIFO_EN (1 << 2)
25# define UDC_CLR_EP (1 << 1)
26# define UDC_RESET_EP (1 << 0)
27#define UDC_STAT_FLG (UDC_BASE + 0x10) /* Endpoint status */
28# define UDC_NO_RXPACKET (1 << 15)
29# define UDC_MISS_IN (1 << 14)
30# define UDC_DATA_FLUSH (1 << 13)
31# define UDC_ISO_ERR (1 << 12)
32# define UDC_ISO_FIFO_EMPTY (1 << 9)
33# define UDC_ISO_FIFO_FULL (1 << 8)
34# define UDC_EP_HALTED (1 << 6)
35# define UDC_STALL (1 << 5)
36# define UDC_NAK (1 << 4)
37# define UDC_ACK (1 << 3)
38# define UDC_FIFO_EN (1 << 2)
39# define UDC_NON_ISO_FIFO_EMPTY (1 << 1)
40# define UDC_NON_ISO_FIFO_FULL (1 << 0)
41#define UDC_RXFSTAT (UDC_BASE + 0x14) /* OUT bytecount */
42#define UDC_SYSCON1 (UDC_BASE + 0x18) /* System config 1 */
43# define UDC_CFG_LOCK (1 << 8)
44# define UDC_DATA_ENDIAN (1 << 7)
45# define UDC_DMA_ENDIAN (1 << 6)
46# define UDC_NAK_EN (1 << 4)
47# define UDC_AUTODECODE_DIS (1 << 3)
48# define UDC_SELF_PWR (1 << 2)
49# define UDC_SOFF_DIS (1 << 1)
50# define UDC_PULLUP_EN (1 << 0)
51#define UDC_SYSCON2 (UDC_BASE + 0x1C) /* System config 2 */
52# define UDC_RMT_WKP (1 << 6)
53# define UDC_STALL_CMD (1 << 5)
54# define UDC_DEV_CFG (1 << 3)
55# define UDC_CLR_CFG (1 << 2)
56#define UDC_DEVSTAT (UDC_BASE + 0x20) /* Device status */
57# define UDC_B_HNP_ENABLE (1 << 9)
58# define UDC_A_HNP_SUPPORT (1 << 8)
59# define UDC_A_ALT_HNP_SUPPORT (1 << 7)
60# define UDC_R_WK_OK (1 << 6)
61# define UDC_USB_RESET (1 << 5)
62# define UDC_SUS (1 << 4)
63# define UDC_CFG (1 << 3)
64# define UDC_ADD (1 << 2)
65# define UDC_DEF (1 << 1)
66# define UDC_ATT (1 << 0)
67#define UDC_SOF (UDC_BASE + 0x24) /* Start of frame */
68# define UDC_FT_LOCK (1 << 12)
69# define UDC_TS_OK (1 << 11)
70# define UDC_TS 0x03ff
71#define UDC_IRQ_EN (UDC_BASE + 0x28) /* Interrupt enable */
72# define UDC_SOF_IE (1 << 7)
73# define UDC_EPN_RX_IE (1 << 5)
74# define UDC_EPN_TX_IE (1 << 4)
75# define UDC_DS_CHG_IE (1 << 3)
76# define UDC_EP0_IE (1 << 0)
77#define UDC_DMA_IRQ_EN (UDC_BASE + 0x2C) /* DMA irq enable */
78 /* rx/tx dma channels numbered 1-3 not 0-2 */
79# define UDC_TX_DONE_IE(n) (1 << (4 * (n) - 2))
80# define UDC_RX_CNT_IE(n) (1 << (4 * (n) - 3))
81# define UDC_RX_EOT_IE(n) (1 << (4 * (n) - 4))
82#define UDC_IRQ_SRC (UDC_BASE + 0x30) /* Interrupt source */
83# define UDC_TXN_DONE (1 << 10)
84# define UDC_RXN_CNT (1 << 9)
85# define UDC_RXN_EOT (1 << 8)
86# define UDC_IRQ_SOF (1 << 7)
87# define UDC_EPN_RX (1 << 5)
88# define UDC_EPN_TX (1 << 4)
89# define UDC_DS_CHG (1 << 3)
90# define UDC_SETUP (1 << 2)
91# define UDC_EP0_RX (1 << 1)
92# define UDC_EP0_TX (1 << 0)
93# define UDC_IRQ_SRC_MASK 0x7bf
94#define UDC_EPN_STAT (UDC_BASE + 0x34) /* EP irq status */
95#define UDC_DMAN_STAT (UDC_BASE + 0x38) /* DMA irq status */
96# define UDC_DMA_RX_SB (1 << 12)
97# define UDC_DMA_RX_SRC(x) (((x)>>8) & 0xf)
98# define UDC_DMA_TX_SRC(x) (((x)>>0) & 0xf)
99
100
101/* DMA configuration registers: up to three channels in each direction. */
102#define UDC_RXDMA_CFG (UDC_BASE + 0x40) /* 3 eps for RX DMA */
103# define UDC_DMA_REQ (1 << 12)
104#define UDC_TXDMA_CFG (UDC_BASE + 0x44) /* 3 eps for TX DMA */
105#define UDC_DATA_DMA (UDC_BASE + 0x48) /* rx/tx fifo addr */
106
107/* rx/tx dma control, numbering channels 1-3 not 0-2 */
108#define UDC_TXDMA(chan) (UDC_BASE + 0x50 - 4 + 4 * (chan))
109# define UDC_TXN_EOT (1 << 15) /* bytes vs packets */
110# define UDC_TXN_START (1 << 14) /* start transfer */
111# define UDC_TXN_TSC 0x03ff /* units in xfer */
112#define UDC_RXDMA(chan) (UDC_BASE + 0x60 - 4 + 4 * (chan))
113# define UDC_RXN_STOP (1 << 15) /* enable EOT irq */
114# define UDC_RXN_TC 0x00ff /* packets in xfer */
115
116
117/*
118 * Endpoint configuration registers (used before CFG_LOCK is set)
119 * UDC_EP_TX(0) is unused
120 */
121#define UDC_EP_RX(endpoint) (UDC_BASE + 0x80 + (endpoint)*4)
122# define UDC_EPN_RX_VALID (1 << 15)
123# define UDC_EPN_RX_DB (1 << 14)
124 /* buffer size in bits 13, 12 */
125# define UDC_EPN_RX_ISO (1 << 11)
126 /* buffer pointer in low 11 bits */
127#define UDC_EP_TX(endpoint) (UDC_BASE + 0xc0 + (endpoint)*4)
128 /* same bitfields as in RX */
129
130/*-------------------------------------------------------------------------*/
131
132struct omap_req {
133 struct usb_request req;
134 struct list_head queue;
135 unsigned dma_bytes;
136 unsigned mapped:1;
137};
138
139struct omap_ep {
140 struct usb_ep ep;
141 struct list_head queue;
142 unsigned long irqs;
143 struct list_head iso;
144 char name[14];
145 u16 maxpacket;
146 u8 bEndpointAddress;
147 u8 bmAttributes;
148 unsigned double_buf:1;
149 unsigned stopped:1;
150 unsigned fnf:1;
151 unsigned has_dma:1;
152 u8 ackwait;
153 u8 dma_channel;
154 u16 dma_counter;
155 int lch;
156 struct omap_udc *udc;
157 struct timer_list timer;
158};
159
160struct omap_udc {
161 struct usb_gadget gadget;
162 struct usb_gadget_driver *driver;
163 spinlock_t lock;
164 struct omap_ep ep[32];
165 u16 devstat;
166 u16 clr_halt;
167 struct usb_phy *transceiver;
168 struct list_head iso;
169 unsigned softconnect:1;
170 unsigned vbus_active:1;
171 unsigned ep0_pending:1;
172 unsigned ep0_in:1;
173 unsigned ep0_set_config:1;
174 unsigned ep0_reset_config:1;
175 unsigned ep0_setup:1;
176 struct completion *done;
177 struct clk *dc_clk;
178 struct clk *hhc_clk;
179 unsigned clk_requested:1;
180};
181
182/*-------------------------------------------------------------------------*/
183
184#ifdef VERBOSE
185# define VDBG DBG
186#else
187# define VDBG(stuff...) do{}while(0)
188#endif
189
190#define ERR(stuff...) pr_err("udc: " stuff)
191#define WARNING(stuff...) pr_warn("udc: " stuff)
192#define INFO(stuff...) pr_info("udc: " stuff)
193#define DBG(stuff...) pr_debug("udc: " stuff)
194
195/*-------------------------------------------------------------------------*/
196
197/* MOD_CONF_CTRL_0 */
198#define VBUS_W2FC_1510 (1 << 17) /* 0 gpio0, 1 dvdd2 pin */
199
200/* FUNC_MUX_CTRL_0 */
201#define VBUS_CTRL_1510 (1 << 19) /* 1 connected (software) */
202#define VBUS_MODE_1510 (1 << 18) /* 0 hardware, 1 software */
203
204#define HMC_1510 ((omap_readl(MOD_CONF_CTRL_0) >> 1) & 0x3f)
205#define HMC_1610 (omap_readl(OTG_SYSCON_2) & 0x3f)
206#define HMC (cpu_is_omap15xx() ? HMC_1510 : HMC_1610)
207
208

source code of linux/drivers/usb/gadget/udc/omap_udc.h